Hot Air Element - 550 watt - 120 Volt

550 watt replacement heating element for the following Polyvance nitrogen welders:

• 8000 - Analog Nitro-Fuzer Nitrogen Plastic Welder
• 8001 - Analog Nitro Fuzer, Dual Gas, No Cart
• 8002 - Analog Nitro Fuzer, Dual Gas, with Cart
• 8003 - Analog NitroFuzer with Generator and Cart
• 8200 - Digital Nitro-Fuzer, Single Gas, No Cart
• 8201 - Digital Nitro Fuzer, Dual Gas, No Cart
• 8202 - Digital Nitro Fuzer, Dual Gas, with Cart
• 8203 - Digital NitroFuzer with Generator and Cart
• 6049 - Nitro Fuzer Lite (without cart)
• 6049-C - Nitro Fuzer Lite (with cart)
• 6050HA
• 6051
• 6053
• 6056
• 6057
• 6057-C
• 6058
• 6058-CG
• 6059
• 6059-CG
• 6066-CG
• 6080-CG
• 6085
• 6085-C

This element also works on:

• This element is a direct offset to the Laramy LP-27A 550 watt replacement heater element.
• This element is a direct offset to the ProSpot 82-0550 element that is used on the ProSpot NP-3.
• This element also fits the Bumper Smith Nitrogen Welding Station.
• This element also fits the Dent Fix DF-EZN1 and DentFix DF-EZN1G nitrogen welders.

How to test your element

To test your element, you will need a multi-meter. You can test it 1 of 2 ways.

Ohms

Ohms setting:
Set your multi-meter to the "Ohms" (?) setting. Touch the brass ends of the element with the leads of the multi-meter.

• You will get a reading of 26.2 ohms (± 1 ohm) if the element is GOOD.
• You will get a reading of 0 (ZERO) if the element is BAD.

Continuity

Continuity setting:
Set your multi-meter to the "Continuity" setting. Touch the metal ends of the element with the leads of the multi-meter.

• You will get a reading of 0 (ZERO) if the element is GOOD. Some multi-meters beep when there is continuity. If your multi-meter beeps, then the element is GOOD.
• You will get a reading of 1 (One) if the element is BAD. Some multi-meters beep when there is continuity. If your multi-meter does NOT beep, then the element is BAD.

High Resolution Image(s) (opens in a new tab/window)

High Resolution Image